Ivoclar Te Econom Flow Refill

US$22.00US$32.00 (-31%)

SKU: N/A Categories: , ,

Ivoclar Te Econom Flow Refill

Light-curing, radiopaque, flowable composite

Indications :-

  • Restorative therapy for mini-cavities of all types
  • Small posterior restorations (Classes I, II)
  • Classes III, IV, V restorations
  • Preventive resin restorations

Features :-

  • Broad indication spectrum
  • Optimal handling
  • Easy access to even the smallest cavities
  • Accurate and economic application
  • Available in shades A2 and A3

Key Specifications :-


Consists of dimethacrylates (37 % wt), inorganic fillers (62 % wt or 38 % vol) with a particle size between 0.04 and 7 µm, initiators, stabilizers and pigments (1 % wt).

Packaging :-

  • 1 x 2gm syringe

Direction to Use :-

  • Select the shade. For facilitated access to the treatment field, the flexible and patient-friendly mouth opener OptraGate can be used.
  • Establish sufficient isolation, preferably with a rubber dam (complete isolation is ensured with, for example, the anatomically shaped OptraDam Plus).
  • Prepare the cavity according to the requirements of the adhesive technique.
  • Clean the cavity with water spray.
  • Air dry the cavity.
  • Apply a pulp protector (calcium hydroxide) if needed; only cover areas close to the pulp and subsequently apply a pressureresistant cement (e.g. Vivaglass Liner).
  • Place a matrix (e.g. the selectively thinned OptraMatrix) and an interdental wedge, if required.
  • Apply Eco-Etch on the enamel and then on dentin and allow a reaction time of 30 seconds on enamel and 15 seconds on dentin. After that, thoroughly rinse with water spray and dry the tooth surfaces with oil-free compressed air. Avoid dehydrating the dentin.
  • Apply a generous amount of Te-Econom Bond on enamel and dentin, using the enclosed applicator brush. Brush the material gently into the dentin for 10 s. Next, evaporate any remaining solvent with a slow stream of air. Lightcure the adhesive according to the curing time recommendations below. Ensure complete coverage of the preparation surface.
  • Apply Te-Econom Flow in layers of a max. of 2 mm and light cure according to the curing recommendations below. Apply Te-Econom Plus in layers of max. 2 mm and adapt/contour the material with a suitable instrument (e.g. OptraSculpt). The OptraContact instrument can be used to selectively position high-quality proximal contacts. Polymerize each layer individually according to the table below. Hold the light emission window as closely as possible to the surface of the restorative material.
  • Finish the restoration with suitable finishers or fine diamonds. Subsequently, check the occlusion. Polish with silicone polishers (e.g. OptraPol Next Generation).

Additional information


A2, A3

Average Rating


( 2 Reviews )
5 Star
4 Star
3 Star
2 Star
1 Star

Only logged in customers who have purchased this product may leave a review.

2 Reviews For This Product

  1. 02

    by Bre Cral

    Easy access to even the smallest cavities.

  2. 02

    by brid

    Easy access to even the smallest cavities.Accurate and economic application. must buy.

Main Menu

Ivoclar Te Econom Flow Refill

Ivoclar Te Econom Flow Refill

US$22.00US$32.00 (-31%)

Add to basket