DentGist NanoCom Flowable Composite Refills 2g
DentGist NanoCom Flow is an excellent flowable composite that delivers high strength & wear resistance. It is Characterized by optimum surface affinity and penetrates easily into most difficult areas. It combines esthetics as well as flow on demand handling for use.
Features:-
- Ease of use
- Easy adaptation to cavity preparation
- Does not stick to the composite filling instruments
- Exceptional radiopacity
- Flowable consistency
- Excellent color stability
- Durable restorations and maintain a gloss shine for long time
- It can be polished to a high gloss finish ensuring optimum esthetics
Indications:-
DentGist NanoCom Flow is indicated for direct filling of class V (Cervical Caries), root erosions, wedge shaped defects, fillings of anterior teeth (Class III & IV), small fillings in posterior teeth, repair of composite and ceramic veneers, block out of undercuts, adhesive cementing of composite and ceramic restorations.
Composition:-
- Bisphenol A Glycidyl Methacrylate
- Ethoxlated Bisphenol A Dimethacrylate
- Urethane Dimethacrylate
- Triethylene Glycol Dimethacrylate
- Silanated Barium Glass Powder
- Amorphous Fumed Silica
Storage:-
- Store at a temperature between 10°C to 24°C. Close the cap carefully after use. Keep away from moisture.
- Isolation : Rubber dam is the preferred method of isolation
- Cavity preparation : Prepare cavity with minimal tooth reduction. Bevel cavo surface enamel margins
- Apply Etchant Gel to enamel and dentin surfaces for 15 seconds. Rinse thoroughly for 15 seconds with water
- Dry with clean, oil-free, air without desiccating the dentin
- Do not allow etched surface to become contaminated with saliva or blood during the bonding procedure
- Adhesive : Immediately after blotting, apply 2-3 consecutive coats of adhesive to etched enamel and dentin for 15 seconds with gentle agitation using a fully saturated applicator. Remove excess solvent by gently drying with dry air for at least 5 sec to ensure uniform glossy surface. Light cure for 20-30 seconds
- Apply the material with applicator tip directly in the cavity and pre contour with a suitable instrument.
- The layer should not be thicker than 2mm.
- Light cure for 40 sec using standard curing light
Reviews
There are no reviews yet.