1. Cleaning of tooth surface Clean the tooth surface following the standard method
2. Isolation Isolate with rubber dam etc following the standard method
3. Preparation
3-1. When storing these materials in a refrigerator, allow them to reach room temperature before use
3-2. Attach a needle tip following the procedures below: ¾Remove the shield cap by turning it slowly ¾Attach a needle tip by turning it in clockwise until it is securely attached
4. Pretreatment of tooth surface Dispense adequate amount of Primer on a V-DISH. Apply on the enamel surface of the pit and fissure using a brush. Leave undisturbed for 5 sec
5.Gently air blow for about 3 sec and then dry with stronger stream of air until a thin and uniform bonding layer is obtained. ¾Primer must be closed immediately after dispensing as it contains volatile components
6. Filling of the paste Apply necessary amount of the paste directly to the pit and fissure or it may also be extruded onto a paper pad to be applied to the pit and fissure with a suitable instrument. ¾The paste dispensed onto the paper pad should be shielded from ambient light by light-shielding cover to avoid unintended polymerization of the material
7. Light-curing Light-cure using a dental light-curing unit
8. Removal of uncured material Remove uncured material on the surface with an alcohol moistened cotton ball etc
Shofu BeautiSealant Complete Set:
- 1 x 1.2g Syringe BeautiSealant Paste
- 1 x 3ml BeautiSealant Primer
- 50 x Microbrush Fine (Pink)
- 25 x V-Dish
Shofu BeautiSealant Refill:
- 1 x 1.2g Syringe BeautiSealant Paste
- Needle Tips
by Elaia
high shear bond strength