Dentsply DeTrey Conditioner 36 For Etching & Dentin Conditioning

US$43.00US$69.00 (-38%)

In stock

DeTrey Conditioner 36 is a blue-tinted gel containing 36 % phosphoric acid for the etching of tooth enamel and conditioning of dentine prior to bonding with resin-based materials.

Estimated Free Delivery Between Thursday 13th October - Saturday 5th November
Category:

Dentsply DeTrey Conditioner Etching & Dentin Conditioning

DeTrey Conditioner 36 is a blue-tinted gel containing 36 % phosphoric acid for the etching of tooth enamel and conditioning of dentine prior to bonding with resin-based materials.

INDICATIONS :-

  • Enamel etch technique in connection with composite and compomer restorations.
  • Total etch technique in connection with composite and compomer restorations.

CONTRAINDICATIONS :-

  • Application to dentine close to the pulp (less than 1 mm)

Key Specifications :-

COMPOSITION :

  • Phosphoric acid
  • Highly dispersed silicon dioxide
  • Detergent
  • Pigment
  • Water

Packaging :-

  • 2 x 3ml Syringes Each
  • 25 x Applicator Needles

Direction to Use :-

1. Cleaning

  • Clean unprepared enamel with a rubber cup and pumice or a cleaning paste such as Nupro® Prophylaxis Pastes
  • Wash thoroughly with water spray and air-dry. Clean freshly cut enamel and dentine with water spray and then air-dry

2. Acid Conditioning of Enamel and Dentine (Total Etch Technique)

  • It is recommended to follow the Total Etch Technique described below: Remove cap from the end of the syringe. Attach disposable needle tip to end of the syringe. Turn tip clockwise to assure that it is fully seated. Gently extrude gel directly to surface/s to be treated. Needle tip may be bent for easy access. Start to apply DeTrey Conditioner 36 gel (36% phosphoric acid) to the cavity surfaces at the enamel margins
  • For best results, condition enamel for at least 15 seconds and dentine for 15 seconds or less. Discard needle after use as needle may clog if gel is allowed to dry inside. Replace original cap

3. Rinsing and Drying

Remove gel with aspirator tube and /or vigorous water spray and rinse conditioned areas thoroughly for at least 15 seconds. Further treatment of the conditioned area depends on the adhesive material which is applied following the conditioning procedure. Consult respective directions for use

Once the surfaces have been properly treated, they must be kept uncontaminated. If salivary contamination occurs, thoroughly clean with vigorous water spray, dry, and repeat conditioning procedure of enamel for 5 seconds only. Rinse as described above. Proceed with adhesive procedure.

Average Rating

4.86

21
( 21 Reviews )
5 Star
85.71%
4 Star
14.29%
3 Star
0%
2 Star
0%
1 Star
0%
Add a review

Your email address will not be published.

21 Reviews For This Product

  1. 21

    by luca

    Fast efficient service and delivery👍

Main Menu

Dentsply DeTrey Conditioner 36 For Etching & Dentin Conditioning

US$43.00US$69.00 (-38%)

Add to Cart